The original frame is weak in many places and was
designed more for indoor flying. A lot of people work on
the Roswell Flyer and they all designed their own frame
using carbon pipes. I decided to buy the carbon upgrade
frame. As usual, all models: Roswell Flyer (sold out),
HMX4 (copy of previous), Dragnaflyer are sharing the same
design and are fully compatible. They were all created by
the clever Mike Dammar from www.spectrolutions.com
Assembling
Content of the upgrade Kit.
The manual given explain everything and is completed. All
screws, heat rubber for isolation, and a small hex key is given.
Nice job. The overall frame is light and the wires are hidden in
each carbon tube. A spare carbon tube is also in the kit.
Aerodynamic canopy, very light, the circuit board is
maintian by the four pylons.
Maybe the motor mount has a little too much flexion. Let
see if it survive in a small crash. Note that the pinion
is now
after the motor mount and no more inside the imaginary
inner circle. It will also be in contact with the ground
in case
of crash.
Â
final throughs
The kit is not overprice and
the frame seems to be reliable and light. A must for all old
roswell flyer!
TIPS
If you think you can not save the machine (crash) stop
immediately the power, it will many times save your
blades